solid-liquid interface

To simulate the culture of Monascus on solid-state fermentation , the simulated system gas-solid interface was proposed.

采用界面培养系统,模拟红曲霉 固态发酵 过程.

Crystals in an unsaturated solution dissolve, with subsequent diffusion away from the solid-liquid interface.

当晶体溶解在不饱和溶液中时，分子就会在固液界面处产生相应的扩散。

Crystal growth velocity increased gradually followed by the decrease of heating temperature. When heating temperature was closer to crystallization temperature, rate of change of crystal growth velocity was more drastic, temperature gradient and the convexity ratio of solid-liquid interface decreased.

随加热温度的降低，晶体生长速率逐渐增大，加热温度愈接近结晶温度，晶体生长速率变化率就愈剧烈；界面凸出率及晶体/熔体中温度梯度随之减小。

By analyzing the factors influencing solid-liquid interface shape, it is said that ACRT is a useful and effective method to improve the solid-liquid interface shape at present.

在分析影响固液界面形态因素的基础上，认为加速坩埚旋转技术是目前改善固液界面形态的较有效方法。

Monte Carlo Simulation on Adsorption Conformation of Amphiphilic Comb-like Polymer at Solid-liquid Interface

两亲性梳形高分子在固液界面吸附形态的Monte Carlo模拟

Expressions for the heat transfer fluxes at the interface of a solid surface and a gas are given for different Knudsen-nubmer regimes. There expressions contain both a gas-reflection and a thermal accommodation coefficient.

该文给出了稀薄气体在不同克努曾数区域下的气-固界面间的传热表达式，这些表达式中包含了气体反射系数和热适应系数。

Solid-state hard drive interface specification and definition, function and usage of ordinary hard drive with the same shape and size of product is also consistent with the ordinary hard disk.

固态硬盘的接口规范和定义、功能及使用方法上与普通硬盘的相同，在产品外形和尺寸上也与普通硬盘一致。

The solid-liquid interface moves away from the heat transfer surface , therefore, it makes phase change problem-linear.

由于相变过程中固液位置不断移动, 使得相变问题具有非线性的特征.

Crystals in an unsaturated solution dissolve, with subsequent diffusion away from the solid-liquid interface .

当晶体溶解在不饱和溶液中时, 分子就会在 固液 界面处产生相应的扩散.

Results showed that growth velocity decreased gradually and temperature gradient in crystal/ melt and the convexity ratio of solid-liquid interface increased followed by the increase of heat dissipation ability of the thermal exchanger.

结果表明：随热交换器散热能力的增加，晶体生长速率逐渐减小，晶体/熔体中温度梯度、固液界面凸出率随之增大。

The Determination of Temperature Gradient in Front of the Solid-Liquid Interface during Unidirectional Solidification of Metals

金属单向凝固过程中固&液界面前沿液相中温度梯度的确定

Research on the Solid-Liquid Interface Stability of Multicomponent Alloys with CALPHAD Method

耦合热力学计算研究多元合金的凝固界面稳定性

Two solid-state, high-resolution pressure transducers provide the interface to the computer.

两个实心 、 高分辨率 压力能量转换器提供传送到计算机的界面.

Studies suggested that it has greater thermal diffusion coefficient because alumina high-temperature melt, temperature wave was relatively apt to pass to solid-liquid interface, so that caused the temperature of the interface to gurgitations;

研究表明由于氧化铝高温熔体具有较大的热扩散系数，温度波较容易传到固液界面引起界面温度起伏；

Design of Solid State Disk Controller with SATA Interface

基于SATA接口的固态硬盘控制器设计